Smaller specialty trades and property maintenance are handled by the same trusted in-house W-2 team that delivers our large-scale projects.
View All Property ServicesPatch it, tape it, and match the texture so you cannot tell where the repair was.
Home Ready Group Construction provides expert drywall repairs for homeowners across Salt Lake City and the Wasatch Front. We fix holes, cracks, and water damage. Then we blend the patch into your existing wall so the repair stays invisible under paint.
Most DIY patches stand out because the texture does not match. A mismatched finish draws the eye to the damage area. Because proper blending takes the right tools and technique, hiring a pro saves you time and frustration.
Our crew works on dozens of walls each month. Therefore, we know how to match every common Utah texture. A visible patch also hurts resale value because buyers notice bad wall work right away.
Since first impressions matter during showings, clean walls help your home sell faster. Property managers trust us to make units look move-in ready between tenants.
We handle damage of all sizes in homes and offices. Here are the issues we see most often.
Doorknobs, furniture bumps, and pulled anchors leave holes in walls. Small holes get a mesh patch and two coats of compound. However, larger holes need a new piece of drywall. We cut the piece to fit, secure it to framing, and then tape and mud the seams.
Cracks appear at stress points above doors and windows. In Utah, dry air causes lumber to shrink after construction. Therefore, tape pulls away from joints over time.
We remove the old tape, re-tape the joint, and apply thin coats of compound. For recurring cracks, we use flexible compound that moves with the structure.
Water-stained drywall needs more than a cosmetic fix. First, we find and stop the water source. Then we cut out all soft material back to solid board.
We check for mold on the framing behind the wall. Because wet drywall weakens fast, prompt removal prevents further spread.
We follow a clear process for every project. Since each step builds on the last, order matters.
First, we lay drop cloths and mask off nearby surfaces. Drywall dust spreads quickly during sanding. Therefore, we contain the mess before we start. We move furniture away from the work area.
Next, we install new drywall where needed. We tape all seams with paper or mesh tape. Then we apply setting compound for the base coat. Because setting compound shrinks less, it creates a stronger base than premixed mud alone.
Once the patch is smooth, we apply texture to match your walls. We test on a scrap board first to confirm the pattern. We adjust spray pressure and knife angle until the look is right.
Common textures include orange peel, knockdown, smooth, and skip trowel. According to the Gypsum Association’s finishing guide, proper finishing levels ensure long-term durability and a consistent surface across the wall.
Finally, we prime all repaired areas with PVA drywall primer. This step seals the new compound so paint covers evenly. Without primer, the repair flashes through the top coat. Therefore, priming is essential so the repair blends in and disappears.
Utah homes feature several common wall textures. We match all of them during drywall repairs.
Orange peel is the most common texture along the Wasatch Front. It has a fine bumpy surface. We match it by spraying thinned compound through a hopper gun. We control tip size and air pressure to get the right splatter density.
Knockdown starts as a heavy splatter coat. Then we flatten it with a wide knife while still wet. Timing matters because flattening too early causes smears. Therefore, we test on cardboard first to dial in the right moment.
Skip trowel is a hand-applied texture common in custom Utah homes. A curved knife drags across thin compound at a low angle. The blade skips over the surface and leaves overlapping arcs. Because each pass is unique, matching takes practice and feel.
Choosing a pro for this work gives you several clear benefits. First, you save hours of trial and error. You avoid buying tools you will only use once. The result looks factory-finished rather than patched.
Matched walls protect your home value. Smooth surfaces signal good maintenance to buyers and inspectors. Therefore, our drywall repairs pay for themselves when you sell or refinance.
Home Ready Group handles single patches and full-room drywall repairs. We serve Salt Lake City, Park City, and all Wasatch Front communities. Contact us for a free estimate on your next wall restoration project. Because every wall is different, we tailor our approach to your specific texture and finish.
Most textures, yes, knockdown, orange peel, and smooth. Hand textures are harder but we get close. We test on a patch before blending.
Compound needs to dry between coats, so most patches take a day or two across a couple visits. Rushing it leaves cracks and flashing.
Yes, once the leak source is fixed. We cut out damaged board, check for mold, and replace it. Painting over a stain without this just hides the problem.
We can prime and paint the patch. Matching old paint sheen and color can flash, so a full-wall repaint sometimes looks best. We advise either way.
Have a question we did not cover here? Read our full FAQ.
Let’s discuss your project. We respond within 48 hours. Prefer to talk now? Call (385) 515-6688.